Purmo Analog Basic RF Manual do Utilizador descarregar pdf (Página 9)

USER GUIDE

CONFIGURATION SWITCH

Sensor mode 3&4 :

- Regulation on internal room

- Regulation on external probe

- Regulation internal room sensor

with lower limit floor on ext. probe

- Regulation on internal room sensor

with upper limit floor on ext. probe

static differential

proportional

Regulation mode 2:

NC Actuator

NO Actuator

Actuator type 1:

Dual Sensing Thermostat 230Vac ANO WFHT 022 (20221)

Dual Sensing Thermostat 230Vac ANC WFHT 023 (20222)

TECHNICAL CHARACTERISTICS

MODES DESCRIPTION

- Electronic thermostat with night reduction mode for water floor heating

systems controlled by actuators.

- External pilot wire for night reduction, equipped with a switch to select

comfort, reduction or clock mode.

- Possibility to regulate either the floor or room temperature, or combined

(in this case, the floor sensor is used as temperature limiter)

- Silent (triac output), to be connected directly to actuators (see connecting

drawing on the installation sheet) or to our Modular connecting system.

(In this case please refer to the connecting box datasheet)

LED INDICATOR

Red: - Heating indication

Green: - reduction mode by clock (pilot wire)

Orange: - Heating during reduction mode by clock (pilot wire)

Red blinking: - 0.5 second cycle => Internal & external sensor failures

- 1 second cycle => Internal sensor failure

- 2 seconds cycle => External sensor failure

Floor limit

settin

Room

settin

Select

mode.

Configuration

switch.

LED Indicator.

Screw connector for

external sensor.

Screw connector for

Power supply,

output and

clock (pilot wire)

PPL IMP 1024A

1 2 3 4

Measured temperature

precision

0.1°C (or 0.2°F)

Operating temperature

0°C - 50°C (or 32°F – 122°F)

Setting temperature range

5°C – 30°C (or 41°F - 86°F)

Floor limiting temperature

range

10°C – 40°C (or 50°F - 104°F)

Regulation

characteristics

Proportional band 10min for 2°K

or Static differential 0.5°K

Electrical Protection

Class II - IP30

Power Supply

230 VAC +/- 10%

Output

TRIAC output 230 VAC, 75 W max.

(15 actuators)

External Floor sensor

NTC (10K Ohms) 3m

Soft version

V 1.4x

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 33 34

Comentários a estes Manuais

Sem comentários

Purmo Analog Basic RF Manual do Utilizador Página 9

Comentários a estes Manuais

Manuais e produtos relacionados com Termóestatos Purmo Analog Basic RF