Purmo Analog Basic RF Manual do Utilizador descarregar pdf (Página 13)

PPL IMP 1094 A

USER GUIDE

CONFIGURATION SWITCH

1 2 3 4

Sensor mode 3&4 :

- Regulation on internal room

- Regulation on external probe

- Regulation internal room sensor

with lower limit floor on ext. probe

- Regulation on internal room sensor

with upper limit floor on ext. probe

static differential of

or proportional on

Regulation mode 2:

NC Actuator of

NO Actuator on

Actuator type 1:

off

Dual Sensing public area Thermostat 230

ac ANO WFHT 032 (20321)

Dual Sensing public area Thermostat 230Vac ANC WFHT 033 (20322)

TECHNICAL CHARACTERISTICS

MODES DESCRIPTION

- This thermostat is specially made for public area (school, office ….)

- Electronic thermostat with night reduction mode for water floor heating

systems controlled by actuators.

- External pilot wire for night reduction, equipped with an internal switch to

select comfort, reduction or clock mode.

- Possibility to regulate either the floor or room temperature, or combined

(in this case, the floor sensor is used as temperature limiter)

- Silent (triac output), to be connected directly to actuators (see connecting

drawing on the installation sheet) or to our Modular connecting system.

(

In this case

lease refer to the connectin

box datasheet

)

LED INDICATOR

Red: Heating indication

Green: reduction mode by clock (pilot wire)

Orange: Heating during reduction mode by clock (pilot wire)

Red blinking: - 0.5 second cycle => Internal & external sensor failures

- 1 second cycle => Internal sensor failure

- 2 seconds cycle => External sensor failure

Floor limit

settin

Room

settin

Select

mode.

Configuration

switch.

LED Indicator.

Screw connector for

external sensor.

Screw connector for

Power supply,

output and

clock (pilot wire)

Measured temperature

precision

0.1°C (or 0.2°F)

Operating temperature

0°C - 50°C (or 32°F – 122°F)

Setting temperature range

5°C – 30°C (or 41°F - 86°F)

Floor limiting temperature

range

10°C – 40°C (or 50°F - 104°F)

Regulation

characteristics

Proportional band 10min for 2°K

or Static differential 0.5°K

Electrical Protection

Class II - IP30

Power Supply

230 VAC +/- 10%

Output

TRIAC output 230 VAC, 75 W max.

( 15 actuators)

External Floor sensor

NTC (10K Ohms) 3m

Soft Version

V 1.4x

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 33 34

Comentários a estes Manuais

Sem comentários

Purmo Analog Basic RF Manual do Utilizador Página 13

Comentários a estes Manuais

Manuais e produtos relacionados com Termóestatos Purmo Analog Basic RF